Ranger 2AM

The following FAQs relate to the Ranger 2AM transmitter.

  • Q. How can I change the frequency on my transmitter?
    • A. Simply swap out the crystals. Try to stay as close as you can to the original channel for optimum performance.
  • Q. What other receivers will my Ranger work with?
    • A. You can use any manufacturers AM receiver provided you use the proper Hitec AM crystal.
  • Q. I would like to have the ratchet to use with my radio, where can I get one?
    • A. If one did not come with your system you can contact Hitec @ (858) 748-8440 and we will send you one at no charge.
  • Q. The light on my transmitter will not come on and nothing is happening.
    • A. Check the battery tray and make sure the batteries are touching the contacts. Sometimes you have to roll the batteries around until they all make contact.
  • Q. How do I install the ratchet in my transmitter?

    • A. Open the back of the transmitter and remove the spring and the spring lever from the gimbal. Then screw the included ratchet down. Please refer to the following picture for part placement.

    Ratchet

    Radios