Hitec Japan
Hitec Korea
Hitec Germany
Multiplex USA
Go
Home
Products
New Products
Aircraft Radios, Receivers and Accessories
Surface Radios, Receivers and Accessories
Digital Servos
Analog Servos
Chargers & Setup Equipment
Parts & Accessories
Support
Warranty & Service
2.4GHz Firmware & Software Updates
Manuals
Software Downloads
Service Bulletins
FAQ's
Where To Buy
Team Hitec
Team Hitec Pilots
Team Hitec Drivers
Contact Us
Customer Service & Repair
Sales Department
For Hobby Shops
Hitec Product Distributors
International Distributors
HOME
Support
FAQ's
FAQs
Radios
Prism 7 and 7x
Q. Why do the centers on my servo move when I switch from high to low dual rate?
Q. Why do the centers on my servo move when I switch from high to low dual rate?
A.
The gimbals may need to be recalibrated. You would need to send it in to our service center for repair.
Prism 7 and 7x
Q. How can I change the frequency on my transmitter?
Q. Is my transmitters trainer function compatible with any other manufacturers radios?
Q. What other receivers will my Prism work with?
Q. Why is my elevator trim not working?
Q. Why do the centers on my servo move when I switch from high to low dual rate?
Q. When I set the end point on my servo, it will only affect one direction.
Q. Why can I not run two different mixes at the same time or mix any channel that I want?
Q. What is the maximum range of the Prism transmitter?
Q. How do I do a range check?
Q. Will my Prism work with other PCM receivers?
Q. Can I change my Prism over for use on 75MHz?
Close
Close
