HOME
Support
FAQ's
FAQs
Radios
Prism 7 and 7x
Q. When I set the end point on my servo, it will only affect one direction.

Q. When I set the end point on my servo, it will only affect one direction.

A. Endpoints will automatically default to one side only. You must move the stick to the side you want to set and then input the percentage you desire.

Prism 7 and 7x

Q. How can I change the frequency on my transmitter?
Q. Is my transmitters trainer function compatible with any other manufacturers radios?
Q. What other receivers will my Prism work with?
Q. Why is my elevator trim not working?
Q. Why do the centers on my servo move when I switch from high to low dual rate?
Q. When I set the end point on my servo, it will only affect one direction.
Q. Why can I not run two different mixes at the same time or mix any channel that I want?
Q. What is the maximum range of the Prism transmitter?
Q. How do I do a range check?
Q. Will my Prism work with other PCM receivers?
Q. Can I change my Prism over for use on 75MHz?