Hitec Japan
Hitec Korea
Hitec Germany
Multiplex USA
Go
Home
Products
New Products
Aircraft Radios, Receivers and Accessories
Surface Radios, Receivers and Accessories
Digital Servos
Analog Servos
Chargers & Setup Equipment
Parts & Accessories
Support
Warranty & Service
2.4GHz Firmware & Software Updates
Manuals
Software Downloads
Service Bulletins
FAQ's
Where To Buy
Team Hitec
Team Hitec Pilots
Team Hitec Drivers
Contact Us
Customer Service & Repair
Sales Department
For Hobby Shops
Hitec Product Distributors
International Distributors
HOME
Support
FAQ's
FAQs
Radios
Flash 5
Q. Why do the centers on my servo move when I switch from high to low dual rate?
Q. Why do the centers on my servo move when I switch from high to low dual rate?
A.
The radio may require recalibration. Return the transmitter to Hitec service for evaluation.
Flash 5
Q. How can I change the frequency on my transmitter?
Q. Is there another manufacturer that has a radio that my transmitters trainer function is compatible with?
Q. Why is my elevator trim not working?
Q. When I set the end point on my servo, it will only affect one direction.
Q. Why do the centers on my servo move when I switch from high to low dual rate?
Q. What other receivers will my Flash work with?
Q. What is the maximum range of the Flash transmitter?
Q. How do I do a range check?
Q. When I use elevon mixing, how do I adjust the throw of the elevator only?
Q. Does Hitec make the Flash System X radios in the Ham Band?
Q. Will this transmitter work with full house sail planes?
Q. When I enable aileron-rudder mix, the rudder only moves in one direction when the aileron stick is moved?
Q. When I enable the ELEVON mix, my elevator behaves like an aileron and visa versa.
Q. Why is my receiver not working with My Flash when I have the EPA and Dual Rates at 125%?
Q. How do I use my transmitter in a buddy situation?
Close
Close
